Welcome, Guest. Please Login or Register
Decware Audio Forums
11/04/24 at 00:43:39 




Most recent 50 posts

Pages: 1
Send Topic Print
16 Ohm Speakers on 8 Ohm Taps (Read 947 times)
ihmeyers
Verified Member
**




Posts: 45
16 Ohm Speakers on 8 Ohm Taps
07/31/19 at 21:25:22
 
Looking into buying a used ZMA to go with a pair of Tonians I just bought with 16 ohm PHY drivers.  The amp in question has 4 ohm and 8 ohm taps according to the owner.  How much degradation (if any) would I get using the 8 ohm taps to drive a 16 ohm speaker?  Speaker in question is 99db efficiency of that makes a difference here.

I know in general it's OK but my understanding is that any potential dropoff in sound quality from using the wrong taps varies on amp to amp basis.  Wasn't sure what the case was with the ZMA.

Thanks. Smiley
Back to top
 
 

LDMS Mini w/ LPS, Lampizator GA TRP
Merrill Element 116 Mono Blocks (main system),Wall Audio M-50 SET Mono Blocks
Townshend Allegri Reference Passive Preamp / Totaldac D1 Driver

Hansen Audio The Prince Speakers (main system) Pair of REL G1 MKII
  IP Logged
BAndrade
Seasoned Member
****


Do it once, do it
right. Repeat for
quality life.

Posts: 156
Re: 16 Ohm Speakers on 8 Ohm Taps
Reply #1 - 07/31/19 at 22:13:41
 
You can perhaps send the ZMA to Steve and get the 16 ohm transformer taps connected to the binding post. Because your ZMA is built for 4 and 8 ohm output the 16 ohm transformer leads will have been cut off leaving a small bit behind with shrink tubing on the end for protection. It may be possible to extend these 16 ohm leads by adding wire to them.
Back to top
 
 
  IP Logged
ihmeyers
Verified Member
**




Posts: 45
Re: 16 Ohm Speakers on 8 Ohm Taps
Reply #2 - 07/31/19 at 22:25:32
 
Thanks for the reply.  I have to factor that in to what I'd pay the guy for the amp...
Back to top
 
 

LDMS Mini w/ LPS, Lampizator GA TRP
Merrill Element 116 Mono Blocks (main system),Wall Audio M-50 SET Mono Blocks
Townshend Allegri Reference Passive Preamp / Totaldac D1 Driver

Hansen Audio The Prince Speakers (main system) Pair of REL G1 MKII
  IP Logged
BAndrade
Seasoned Member
****


Do it once, do it
right. Repeat for
quality life.

Posts: 156
Re: 16 Ohm Speakers on 8 Ohm Taps
Reply #3 - 08/01/19 at 01:42:46
 
True.

Or a local tech might be cheaper.

For myself being who I am cannot live with mismatches for long.

For certain the speaker output will be about half that of rated, not certain of other effects.
Back to top
 
 
  IP Logged
Pages: 1
Send Topic Print