Welcome, Guest. Please Login or Register
Decware Audio Forums
05/01/25 at 04:07:02 



Most recent 50 posts

Forums › SPEAKER FORUMS › NFX ‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
DFR-8 cutout (Read 6756 times)
rmt
Ex Member
DFR-8 cutout
08/09/06 at 02:26:04  
[quote author=Zygi  link=1146081910/0#1 date=1146097859]The driver cut out (hole) is 3-19/32" R ...the driver is surface mounted.
BobZ [/quote]

On the HDT support forum this was stated by Zygi.  That would make the cutout diameter 7 3/16 in diameter for the DFR-8.  NFX plans show 7 inch dia.  ??? I don't expect my DFR-8 drivers to get here for several days.  Should I wait till they are here before I make my baffle cutouts?
Back to top
 
 
  IP Logged
Steve Deckert
Administrator
*****


If the 1st watt
sucks why continue?

Posts: 6397
Re: DFR-8 cutout
Reply #1 - 08/09/06 at 20:36:54  
Yes, the DFR-8 cutout is 7-3/16 inches.  The plans are done without knowing what drivers will be used.  Always easier to make a hole bigger then it is to make a hole smaller.  8)
Back to top
 
 
WWW   IP Logged
Pages: 1
Send Topic Print
Forums › SPEAKER FORUMS › NFX ‹ Previous topic | Next topic ›







Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.


Source Forge