Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SPEAKER FORUMS >> NFX >> DFR-8 cutout https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1155090364 Message started by rmt on 08/09/06 at 02:26:04 |
Title: DFR-8 cutout Post by rmt on 08/09/06 at 02:26:04 Zygi wrote on 04/27/06 at 01:30:59:
On the HDT support forum this was stated by Zygi. That would make the cutout diameter 7 3/16 in diameter for the DFR-8. NFX plans show 7 inch dia. ??? I don't expect my DFR-8 drivers to get here for several days. Should I wait till they are here before I make my baffle cutouts? |
Title: Re: DFR-8 cutout Post by Steve Deckert on 08/09/06 at 20:36:54 Yes, the DFR-8 cutout is 7-3/16 inches. The plans are done without knowing what drivers will be used. Always easier to make a hole bigger then it is to make a hole smaller. 8) |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |