I said I was done scaling and gonna do it right with the WO32. But After I put $600 into a new hot water heater. Money became an issue again.
I am never gonna get my sub and horns built

I need projects to keep in shape so out of stuff I had laying around I built this. The MDF I bought.
The box is 10" high and the tapered pipe is 1/2" smaller. other than that it is the same as the WO32.
Each of the subs are ADS 6" @ 4 Ohms. the plate amp is 50x2 into 4 Ohms.
It is not finished yet I am using it to tweak it .
This is not recommended and always hit and miss.
This time it was a hit with the stuff I used.The crossover point is not low enough on the amp,but I am going to try messing around with the guts of the enclosure to compensate.
The woofers have dynamat on them to preventing the basket from ringing.
The wire is braided PA wire used in school intercom systems.
thats about it.
and if I knew the picture was going to be this bad, I would have taken more and better ones before I sealed it up for testing.
Gonna watch a movie of two and try it. I was originally a sub for what was to be my horns that are put on hold again.
so here is a pic

There are some glaring changes but it resembles the WO32 more than it does not.
I got a kick out of it. I mean... really I got a kick out of it.
I still say its better to build it the way you should, but if you don't have the coin and have to build build it the best you can.