Welcome, Guest. Please Login or Register
Decware Audio Forums
10/20/20 at 13:00:44 


       


Pages: 1
Send Topic Print
HR-1 Post size? (Read 2593 times)
DannyJaxon
Verified Member
**




Posts: 6
HR-1 Post size?
04/10/16 at 22:19:11
 
Hi everyone. I have a pair of HR-1s and want to get them off of the floor. I see that they have threaded inserts to accommodate feet. Does anyone know what size screw/thread is needed?  I'm looking at Herbie's Gliders. I'm open to suggestions if other people have had good results using other products. They rest on a suspended oak floor. (Basement below)

Thanks,
Dan
Back to top
 
 
  IP Logged
Archie
Seasoned Member
****




Posts: 2004
Re: HR-1 Post size?
Reply #1 - 04/10/16 at 23:36:28
 
Dan,

There are lots of posts on this subject and quite a few on HR-1s.  I have mine on isolation platforms with good results.
Back to top
 
 

ZLC
Technics 1200G TT w/ Ortofon Jubilee MC cart
ZMC1
ZP3 (25th A Mods)
ZR2 (25th A Mods) -- currently not in use
CSP3 (25th A mods)
ZMA (25th A mods)
Homemade Big Betsy Speakers (F15s)
Silver Cabling
DIY Isolation platforms under amps & TT.
  IP Logged
Lon
Seasoned Member
****


"Love without
guts is
worthless!"
Philip K. Dick

Posts: 17227
Re: HR-1 Post size?
Reply #2 - 04/10/16 at 23:51:32
 
I have my HR-1s on a suspended floor, on top of thick carpet. I've used the Gliders in the past. . . didn't like the results as much as the HR-1s on Iso-Cups, and the best for my situation are the HR-1s on Ingress Audio Rollerblocks. Bob/Ziggy can let you know what tread size these are, originally they should come with treaded rods that have a point on one end.
Back to top
 
 

HR-1,ZTPRE,ZBIT,ZROCK2,SE84UFO3-25th x2, CSP3-25th.Taboo Mk IV; Rega RP3 w/25th mods PS Audio: DMP+DSD,P15,NPC,PowerBases,AC-12 pwr cbls, Statement spkr cbls;Mapleshade:Samson V3; Oppo UDP-205; VooDoo:Cremona+Amati intrcncts, Iso-Pods;headphones:PM1,HD800S,ZMF Ori
  IP Logged
ZYGI
Seasoned Member
****


HR-ONE

Posts: 746
Re: HR-1 Post size?
Reply #3 - 04/16/16 at 02:06:09
 
Sorry, I've been busy working on the new shop in my spare time…Haven't been on the forum all that much.

Danny, The answer to your question is 1/4"-20 thread inserts.

BobZ
Back to top
 
 

All Decware amps and sources, Turning Point Audio speakers
  IP Logged
Pages: 1
Send Topic Print