Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SPEAKER FORUMS >> HR-1 >> HR-1 Post size? https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1460323151 Message started by DannyJaxon on 04/10/16 at 22:19:11 |
Title: HR-1 Post size? Post by DannyJaxon on 04/10/16 at 22:19:11 Hi everyone. I have a pair of HR-1s and want to get them off of the floor. I see that they have threaded inserts to accommodate feet. Does anyone know what size screw/thread is needed? I'm looking at Herbie's Gliders. I'm open to suggestions if other people have had good results using other products. They rest on a suspended oak floor. (Basement below) Thanks, Dan |
Title: Re: HR-1 Post size? Post by Archie on 04/10/16 at 23:36:28 Dan, There are lots of posts on this subject and quite a few on HR-1s. I have mine on isolation platforms with good results. |
Title: Re: HR-1 Post size? Post by Lon on 04/10/16 at 23:51:32 I have my HR-1s on a suspended floor, on top of thick carpet. I've used the Gliders in the past. . . didn't like the results as much as the HR-1s on Iso-Cups, and the best for my situation are the HR-1s on Ingress Audio Rollerblocks. Bob/Ziggy can let you know what tread size these are, originally they should come with treaded rods that have a point on one end. |
Title: Re: HR-1 Post size? Post by ZYGI on 04/16/16 at 02:06:09 Sorry, I've been busy working on the new shop in my spare time…Haven't been on the forum all that much. Danny, The answer to your question is 1/4"-20 thread inserts. BobZ |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |