Forums - WO32 8" Driver

09/09/26 at 19:11:29

Most recent 50 posts
Welcome, Guest. Please Login or Register

Forums » WO32 Support Forum

‹ Previous topic | Next topic ›

Pages: 1

WO32 8" Driver (Read 10121 times)

KDog

Ex Member

WO32 8" Driver
08/30/11 at 07:15:04

Hello,
Is it possible to scale the WO32 for an 8" driver? If so how have people gone about this? Does just shrinking the height work?

If it's possible I was thinking of using two 8" drivers with the following T/S parameters:
Imp: 4ohms
Re: 3.4 ohms
Fs: 28Hz
Qes: 0.31
Qms: 2.1
Qts: 0.27
Vas: 2.05 cu/ft
Xmax: 5.0mm
Sd: 220 cm^2
Spl: 90.8dB/w
Pwr: 150 watts (cont)

Sealed enclosure volumes recommended between 0.25 - 0.37 cu/ft.

Does this sound suitable?
Cheers

IP Logged

Likes:

HT-EXT Seasoned Member Offline NYUK NYUK NYUK Posts: 274 x0\|Mayberry RFD\|USA\|\|0\|0\|NC,North_Carolina	Re: WO32 8" Driver Reply #1 - 09/06/11 at 13:24:01 I would say it can be done. I know 60 built the WO21. There is a post here somewhere with a pic of 60 and the WO21. Too cool !!! HT-EXT
Back to top	" I TRY TO THINK BUT NUT'EN HAPPENS! " CURLY IP Logged Share: Likes:

phattoo Verified Member Offline Posts: 7	Re: WO32 8" Driver Reply #2 - 08/10/16 at 14:17:54 Re: WO32 8" Driver Reply #1 - 09/06/11 at 13:24:01 I would say it can be done. I know 60 built the WO21. There is a post here somewhere with a pic of 60 and the WO21. Too cool !!! HT-EXT Can you post a link to pic or information referenced?
Back to top	IP Logged Share: Likes:

Pages: 1

‹ Previous topic | Next topic ›