Some things for consideration:

1)  Typically a 1k 2w resistor is used in the g2 screen connection.  I'm not sure why its there, but it usually is.  It may have something to do with frequency response, isolating the screen capacitance from the signal.  It may be very subtle as to what this resistor does.  Your design might benefit from two of these resistors, one for each stage.

2)  I think you will have a lot of noise issues with that large of a input pot.  Noise from touching the volume control (or even getting close to it) may be a problem.  I use 47k, 10 times less.

3)  Your bypass caps on the cathode resistors seem a little small.   100-1000uf would be more typical.  Also be aware that the cathode resistor on the output stage is sometimes made excessively large, power wise, so if an output tube shorts it doesn't take the cathode resistor with it.  I've seen anywhere from 5w-25w on amps like this.

4)  I would question the size of the coupling cap.  0.01 uf seems small, 0.1 uf would be a more typical value.

Good luck and let us know how it turns out

Dan