New Err's installed and been done some listening test and straight off I knew things were not quite right. I wasn't sure what sort of sound stage to expect but I did expect the vocals to take centre stage but they just didn't. Getting close up it was obvious the ribbon tweeter is the culprit. One gives a nice clear sound the other all thin and screechy. The connections look fine to me but I'm not experienced enough to look at the ribbon itself to see if al is ok.

Any Suggestions as to what I should do or check?

Thanks

Ian

If those speakers have the resistor and capacitor mounted in the jack plate where you can get to them, you could swap R and C with the other speaker to eliminate or prove if R or C or the connection is the problem.

Dan

Not sure which binding post but after giving them all a bit of a turn everything seems fine.

thanks for the help.

That is good news just what I suspected....here is what happens and a good reason to check connections for the first month or so, it seems after that they never come loose. If you do change a cap, or resistor check again for awhile.

Here's what happens....the edges are pretty sharp, so they make good contact with the wire, the closer you get to the bottom of the wire bore the more chance you have of getting it tight before it reaches the very bottom of the bore, so you think its tight, then it moves just a bit and its loose again. This is all because the bores are large and the leads are so small. Once it finds the true bottom of the bores arc it stays forever.