Decware Audio Forums
07/18/26 at 13:06:47



Most recent 50 posts
Welcome, Guest. Please Login or Register

Forums » ZSP1 Support forum ‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
low volume distorted output (Read 7210 times)
chopchip
Verified Member
**
Offline



Posts: 8
low volume distorted output
06/05/10 at 23:46:08  
i finished the kit but it doesnt work. i have been over it a few times i am probably blind to what i did wrong. i cant figure it out. what is the blue wire from the transformer for.

im at a loss

thanks
Back to top
 
 
  IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
chopchip
Verified Member
**
Offline



Posts: 8
Re: low volume distorted output
Reply #1 - 06/06/10 at 01:49:49  
i measured the voltage B+ at the capitor there and it is zero.

for two caps do you use only one resistor?

thanks
Back to top
 
 
  IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
Hasafraker
Verified Member
**
Offline



Posts: 38
Akron/Canton OH.
Re: low volume distorted output
Reply #2 - 07/26/10 at 11:14:14  
the B+ filter should start with a resister at the yellow wire w/black stripe, that goes to the first filter cap, then another resister to the second filter cap. Your B+ comes off this last leg.
Back to top
 
 
pwells~

SE84DIY w/cce mod, ZSP1, VSPS DIY phono stage w/separate psu, Sansui SR-525 Turntable, Nagaoka MP-100 mm cart, Tekton Design 8.1's 97db@1w, all cables and interconnects DIY. Now we're cookin Wink
WWW hasafraker hasafraker   IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›







Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Heavily modified by Steve Deckert for DECWARE LLC
Source Forge