Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZSP1 Support forum >> low volume distorted output https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1275777968 Message started by chopchip on 06/05/10 at 23:46:08 |
Title: low volume distorted output Post by chopchip on 06/05/10 at 23:46:08 i finished the kit but it doesnt work. i have been over it a few times i am probably blind to what i did wrong. i cant figure it out. what is the blue wire from the transformer for. im at a loss thanks |
Title: Re: low volume distorted output Post by chopchip on 06/06/10 at 01:49:49 i measured the voltage B+ at the capitor there and it is zero. for two caps do you use only one resistor? thanks |
Title: Re: low volume distorted output Post by Hasafraker on 07/26/10 at 11:14:14 the B+ filter should start with a resister at the yellow wire w/black stripe, that goes to the first filter cap, then another resister to the second filter cap. Your B+ comes off this last leg. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |