Welcome, Guest. Please Login or Register
Decware Audio Forums
05/01/25 at 08:17:48 



Most recent 50 posts

Forums › SUPPORT FORUMS FOR ZKITS › ZSP1 Support forum ‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
low volume distorted output (Read 6380 times)
chopchip
Verified Member
**




Posts: 8
low volume distorted output
06/05/10 at 23:46:08  
i finished the kit but it doesnt work. i have been over it a few times i am probably blind to what i did wrong. i cant figure it out. what is the blue wire from the transformer for.

im at a loss

thanks
Back to top
 
 
  IP Logged
chopchip
Verified Member
**




Posts: 8
Re: low volume distorted output
Reply #1 - 06/06/10 at 01:49:49  
i measured the voltage B+ at the capitor there and it is zero.

for two caps do you use only one resistor?

thanks
Back to top
 
 
  IP Logged
Hasafraker
Verified Member
**




Posts: 38
Re: low volume distorted output
Reply #2 - 07/26/10 at 11:14:14  
the B+ filter should start with a resister at the yellow wire w/black stripe, that goes to the first filter cap, then another resister to the second filter cap. Your B+ comes off this last leg.
Back to top
 
 
pwells~

SE84DIY w/cce mod, ZSP1, VSPS DIY phono stage w/separate psu, Sansui SR-525 Turntable, Nagaoka MP-100 mm cart, Tekton Design 8.1's 97db@1w, all cables and interconnects DIY. Now we're cookin Wink
WWW hasafraker hasafraker   IP Logged
Pages: 1
Send Topic Print
Forums › SUPPORT FORUMS FOR ZKITS › ZSP1 Support forum ‹ Previous topic | Next topic ›







Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.


Source Forge