Decware Audio Forums
08/07/26 at 12:00:10



Most recent 50 posts
Welcome, Guest. Please Login or Register

Pages: 1
Send Topic Print
SE84UFO - 120Hz hum and low power output (Read 997 times)
MS-TAS
Verified Member
**
Offline



Posts: 1

SE84UFO - 120Hz hum and low power output
10/19/25 at 20:41:44
 
I'm a studio technician working on the amp noted above.  
The amp has a constant 120Hz hum at about 200nW or -58dBV.  The amp also exhibits pretty significant distortion at about 330mW on each channel, significant being visible disruption of the sine wave (not clipping) on the negative half of the waveform.  THD jumps from 1.5% at 200mW to around 10% at 360mW.
Both channels affected.
Frequency response is also poor, -3dB at 20Hz, and 15kHz with steady decline from 1kHz to 15kHz.

I added 200uF of capacitance to the high voltage power supply and the hum dropped 13dB, but no change in power output.

+320VDC going into output transformers
9VDC on cathode of output devices, replaced the capacitor here just in case, no change.

This is definitely in the output stage, signal on the grid is clean far beyond where output distorts and signal on the grid doesn't have the distortion of the output.

What am I missing?

Back to top
 
 
  IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
MM
Seasoned Member
****
Offline



Posts: 546

Re: SE84UFO - 120Hz hum and low power output
Reply #1 - 10/19/25 at 22:06:59
 
I’m an amateur when it comes to diagnostics on circuits but if it helps, the zkit schematic is here: https://www.decware.com/newsite/ZKIT1.pdf

The only difference is diode rectification instead of a rectifier tube. It’s a pretty simple circuit so not much room for problems.

Good luck!
Back to top
 
 

Lumin T3x | DSR3S IC | SEWE 300b | Crown XLS1000 | ZSTYX SC | Lii F15 & W15 in open baffle | Ecoflow Delta Pro
  IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
CAJames
Seasoned Member
****
Offline

"I've run every
red light on memory
lane."

Posts: 3325

Re: SE84UFO - 120Hz hum and low power output
Reply #2 - 10/20/25 at 03:58:39
 
What about the input and output tubes?
Back to top
 
 

[Volumio | Jay's CDT2 MRK3] -> Denafrips Terminator 2 + Gaia
Sumiko Pearwood -> Mapleknoll Athena -> Luxman SUT -> Mapletree Phono 3E
STR-1002 -> Woo WA22 -> 2x UFO25s, balanced monos
Omega SAM , Hifiman Arya, Audeze LCD-XC
  IP Logged
Share: X Facebook LinkedIn Email WhatsApp Instagram Likes:
Pages: 1
Send Topic Print