Hajj
Ex Member
|
I opened up my SE34-I yesterday to carry the CCE mod on it. Soldering iron, ready Caps, ready
Just to be on the safe side, I read the posts again on the forum concerning the mod, and, as mentioned by ZYGI in one of the posts, the cap should go between pins 1 and 8. But then I read a post made by Steve, stating that for the mod to work on the SE34-I.2 (the second gen SE34 integrated) there's a 1K resistor connecting pins 1 and 3 that needs to be removed first. Looking at my amp, it seems that the SE34-I has that same resistor across pins 1 and 3 on the outer tubes (the ones wired in triode). So my question is, should that resistor also be removed from the SE34-I, just like on the SE34-I.2 in order for the mod to work? I read 4Krow did the mod on his SE34-I. Below is a pic showing the actual internals as well as notes about the resistor and pins Any input is more than welcome. Thanks Nick
|