Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl EQUIPMENT FORUMS >> ZP3 / ZMC1,2,3 >> ZP3 Dead After Tubes Flashing https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1677694032 Message started by Smellman on 03/01/23 at 18:07:12 |
Title: ZP3 Dead After Tubes Flashing Post by Smellman on 03/01/23 at 18:07:12 As the title says my ZP3 shows no signs of power after I noticed some heavy flickering from the voltage regulator and rectifier a couple days ago. I immediately turned it off once I noticed. I tried replacing the both tubes with known working tubes. I even replaced all the other tubes as well just to sure. I verified the power cord and outlet are working. There is no glow from any of the tubes. I would appreciate any advice. If I do need to send it in, does anybody know if their service wait times are as crazily long as a new order? Thanks Sean |
Title: Re: ZP3 Dead After Tubes Flashing Post by HockessinKid on 03/01/23 at 18:20:23 Have you checked the fuse located in the IEC at the rear? Likely have a blown fuse HK |
Title: Re: ZP3 Dead After Tubes Flashing Post by NormD on 03/01/23 at 18:22:01 Check the fuse? It may be inside the receptacle for the power plug as it is on their other equipment. |
Title: Re: ZP3 Dead After Tubes Flashing Post by Smellman on 03/01/23 at 18:33:44 It was the fuse. I never knew where it was located. Thank you both for responding so quickly. Forgive my ignorance again, what size fuse is it so I can have some on hand? |
Title: Re: ZP3 Dead After Tubes Flashing Post by HockessinKid on 03/01/23 at 18:55:58 First check the IEC compartment for spare. Then look at the bottom of the ZP3 or download the owners manual. HK |
Title: Re: ZP3 Dead After Tubes Flashing Post by Smellman on 03/01/23 at 19:03:14 Thanks |
Title: Re: ZP3 Dead After Tubes Flashing Post by Sean on 03/01/23 at 19:33:32 Sean, Should be a 3 amp fuse. Value should also be on the sticker on the bottom. You don’t happen to live in Butler, PA, do you? Screen name rings a bell, I think I bought my Mofi table from you. |
Title: Re: ZP3 Dead After Tubes Flashing Post by 4krow on 03/01/23 at 20:57:38 Also, even though kind of hard to read, it is embossed on the fuse cap. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |