Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
AUDIO FORUMS >> General Discussion and Support >> Amp. recommendation for Wilson Audio Sasha DAW
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1626276799

Message started by Beni on 07/14/21 at 16:33:19

Title: Amp. recommendation for Wilson Audio Sasha DAW
Post by Beni on 07/14/21 at 16:33:19

Dear dear fans of music enjoyment

I would like to run a Decware Zen amp with my Wilson Audio Sasha DAW (Sensitivity 91 dB @ 1W @ 1 meter @1 kHz Nominal Impedance 4 ohms / minimum 2.48 ohms @ 85 Hz).

My listening room is 16 square meters and I sit 3 meters away from the speakers.
Do you see a problem here with the 25th Anniversary Zen Triode Amplifier or would you recommend me another solution (perhaps the Zen Torii MK4) ?

Thank you very much for your answer and kind regards

Benjamin

Title: Re: Amp. recommendation for Wilson Audio Sasha DAW
Post by GroovySauce on 07/14/21 at 16:49:45

What is your current amplification? What SPL do you usually listen at?

I would recommend either the Torii MKIV, soon to be updated to MK V or the ZMA.

If it was me with those speakers I would go for the ZMA with 25th mods.

Title: Re: Amp. recommendation for Wilson Audio Sasha DAW
Post by Beni on 07/14/21 at 18:01:38

Thank you very much for your answer.

I am currently using a McIntosh C53 preamp with the MC462 power amp.
Most of the time I listen around 80dB on average, depending on the mood it may be sometimes over 90dB.

Kind regards
Benjamin

Title: Re: Amp. recommendation for Wilson Audio Sasha DAW
Post by GroovySauce on 07/14/21 at 20:43:53

Of course! and welcome to the forums.

I say look at the ZMA with 25th mods for sure. If you really like to play loud, might want to ask Steve about the Torii Mono's. I haven't experienced them so I cannot comment on them.