Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
EQUIPMENT FORUMS >> SE84UFO2 >> Using SE84ckcs as mono amps
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1499393719

Message started by Obguy on 07/07/17 at 03:15:19

Title: Using SE84ckcs as mono amps
Post by Obguy on 07/07/17 at 03:15:19

Can these amps be used as dual mono amps and if so how do i do it?

Title: Re: Using SE84ckcs as mono amps
Post by Steve Deckert on 07/07/17 at 03:28:32

It is easy to bridge the amps into mono. If you download the current owner's manual there are diagrams on how to do it.

In a nutshell it is just as simple as getting a Y-Cable (2 male, 1 female) for each amplifier's input jacks and a 12 inch piece of wire for each amp to connect the left positive speaker jack to the right negative speaker jack. The remaining unused positive and negative speaker jacks will be used to connect your speaker.

Title: Re: Using SE84ckcs as mono amps
Post by Rivieraranch on 01/08/19 at 15:04:56

I found that I could use a hard splitter connected the source that had one male and two females. Attach two interconnects to each splitter and then two to each amp. It worked fine. And connect the speaker terminals of course.