Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl AUDIO FORUMS >> General Discussion and Support >> Cleaning Decware Amps https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1481215038 Message started by EL Capitan on 12/08/16 at 16:37:18 |
Title: Cleaning Decware Amps Post by EL Capitan on 12/08/16 at 16:37:18 I recently moved to a new house and am ready (finally) to set up my system. I noticed in the TORII MK4 instruction manual about cleaning the input jacks with Q-Tips and alcohol. I am curious if the tube sockets require any cleaning. Should I use DeOxit? Alcohol? Or just leave them alone. Thanks in advance for your comments. Happy Holidays! |
Title: Re: Cleaning Decware Amps Post by Steve Deckert on 12/09/16 at 03:17:05 I've always believed that virtually every electrical connection in a hi-fi system should be absolutely clean. DeOxit is a good contact cleaner that can be used on tube sockets, tube pins, input / output jacks, cable ends, power cords, wall receptacles and speaker binding posts. Cleaning all of these items alone can make more of a difference than you might hear between a $79 and $499+ cable, yet it is largely overlooked by most. Steve |
Title: cleaning Post by maddog07 on 12/09/16 at 18:41:31 +1 to the Zenmaster Steve - Caig and some pipe cleaners/foam swabs will reveal grunge you didn't know was there.... !!!! My issue with Q-tips is all the cotton lint fibers that slough off and tend to get left behind on what I was cleaning. Look around for "foam swabs" which don't leave lint behind IME. In some cases, Q-tips are the only thing that will work, in which case, a little compressed air after the cleaning to make sure any cotton fibers left behind from the Q-tip are vanquished..!!!! |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |