Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR ZKITS >> ZKIT 3 Support forum >> Rev 9 board with extra 1k resistor
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1477927184

Message started by Jinks on 10/31/16 at 16:19:44

Title: Rev 9 board with extra 1k resistor
Post by Jinks on 10/31/16 at 16:19:44

Hi, I just built the rev 9 board version and noticed there is an extra 1k resistor in place of the previous 10k on the older rev board. As this wasn't listed in the parts I did not have the extra resistor so used a 10k in its place. I notice the Crossfeed will work only in the on position and it seems a little left side biased and in the off position there is no right channel feed at all, maybe that 1k is important after all? I have ordered some extra 1k's and we will see, but it sounds clean and refreshing so far :)

Thanks,

Mathew.