Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl AUDIO FORUMS >> General Discussion and Support >> CSP2+ and Taboo II setup https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1456413528 Message started by Hibuckhobby on 02/25/16 at 15:18:48 |
Title: CSP2+ and Taboo II setup Post by Hibuckhobby on 02/25/16 at 15:18:48 OK...I know this has "probably" been done to death, but my google fu is weak and I've looked a lot on this forum. I have a Taboo II and am getting a CSP2+ today. What is a good starting point in terms of setup? Which inputs on Taboo...variable or fixed? I suspect fixed, but then where do I set the volume control on the Taboo? On the CSP2+ do I set the individual gains in the middle and then control the volume with the master? What are the voltage controls for? I have also looked for a manual, but can only find one for a CSP2 online...not the +. Any assistance appreciated. Will be using Taboo for LCD-2's and desktop speakers. The CSP2+ to drive the Taboo and for 150 ohm and up impedance headphones. (Sennheiser HD650 and 700) regards, Hibuck... |
Title: Re: CSP2+ and Taboo II setup Post by Hibuckhobby on 02/26/16 at 14:17:41 Hmmm... no one? Hibuck.... |
Title: Re: CSP2+ and Taboo II setup Post by Lin on 02/29/16 at 19:47:10 I think the CSP3 page will answer your questions. https://www.decware.com/newsite/CSP3.html |
Title: Re: CSP2+ and Taboo II setup Post by beowulf on 03/03/16 at 02:07:10 I don't have a CSP3, but I do use the Taboo II with a McIntosh C220 Preamp I use the fixed inputs as I think it sounds better. Whenever I used variable the volume did not sound consistent. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |