Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl AUDIO FORUMS >> General Discussion and Support >> Endeavor Speakers https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1431613864 Message started by Dave1210 on 05/14/15 at 15:31:04 |
Title: Endeavor Speakers Post by Dave1210 on 05/14/15 at 15:31:04 Anyone know much about this company or the below speakers. We heard the E5 at Axpona. They were in way too small of a room but I think had a lot of potential. Their smaller speaker, the E3, is relatively efficient and supposed to have flat 4 ohm impedance, which should be a good match for tubes. http://www.endeavoraudio.com/products/e-3 |
Title: Re: Endeavor Speakers Post by Lin on 05/14/15 at 23:37:22 While I haven't heard them or even heard of them until now, 87dB 1w/1m (probably inflated a dB or two) wouldn't qualify as "relatively efficient" to me. YMMV |
Title: Re: Endeavor Speakers Post by Dave1210 on 05/14/15 at 23:44:16 Lin...is 90dB@2.83V/meter, really 87 dB 1w/1m for a 4 ohm speaker? I guess I didn't look that closely and saw 90dB, and looked right past the 2.83V... 2.83V = 1 watt @ 8 ohm? 2.83V = 2 watts @ 4 ohm? so they are really stating, 90 dB @ 2 watts vs. 1 watt? |
Title: Re: Endeavor Speakers Post by Lin on 05/14/15 at 23:49:03 With 4 ohm speakers yes, it would be 2 watts at 2.83v. |
Title: Re: Endeavor Speakers Post by Dave1210 on 05/14/15 at 23:58:20 Just saw your post as I was revising mine...makes sense now. I should have paid closer attention...I think the ZMA could drive these speakers, but they are less interesting to me now. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |