Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SPEAKER FORUMS >> DNA Horn >> DNA Build Questions https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1428594601 Message started by Steve Deckert on 04/09/15 at 16:50:00 |
Title: DNA Build Questions Post by Steve Deckert on 04/09/15 at 16:50:00 Quote:
4" is from the top outside edge of the cabinet to the top edge of the speaker cut-out. It is more important to maintain the spacing from the top of the driver to the top of the cabinet so the internal reflections to the port do not change. Not knowing what drivers would be tried makes it impossible to dimension it at the centerline and maintain this critical distance. Quote:
The dimension is 3 1/4". Since the plans are a .pdf file, you can zoom in to enlarge the dimensions and read them clearly. Quote:
I use a combination of felt and foam blocks. See picture: Quote:
Combinations work well. Some ply, some mdf. Carpenters wood glue and clamps. Quote:
The wires typically go through the back (see picture) but there are no rules. Quote:
Yes, the 10PA is wonderful in this cabinet. No changes are being made other than cutout diameter is slightly larger. Quote:
Yes, the SE34I.4 will drive the speakers to a reasonable level in your room, but will be unable to take it much past that point. Steve |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |