Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
AUDIO FORUMS >> General Discussion and Support >> connecting a subwoofer to a Zen se84
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1398348980

Message started by juszat on 04/24/14 at 15:16:20

Title: connecting a subwoofer to a Zen se84
Post by juszat on 04/24/14 at 15:16:20

I have a an Omega single driver speaker ( super 3) set up with a superzen SET amp in my bedroom . Late night i usually lower the volume and some of the low frequency suffers . I am thinking about adding an 8 " sealed subwoofer . My question is what would be the best way to connect the sub to the superzen amp ?

Title: Re: connecting a subwoofer to a Zen se84
Post by deucekazoo on 04/24/14 at 16:11:38

Would that be an 8" powered sub?
If yes, then just Y the signal going into your Zen and run it into the sub. It would be better if you had a pre-amp before your Zen, then it can have two outputs, one for your sub and one for your amp.

Title: Re: connecting a subwoofer to a Zen se84
Post by DBC on 05/03/14 at 14:34:40

Unless you want to invest in a preamp I suggest you select a sub with "Speaker Level" inputs. Connect a second set of speaker cables from your amps Left / Right speaker outputs to the Speaker Level input connections on the sub. I use inexpensive Cat 5 network cable for this connection with very good results in my system.

If you really want to improve lower volume listening then I suggest a Mid Bass Module over the Sub only approach. You can get more info here:

https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1360355711/0#0

Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.