Forums https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZKIT 1 Support forum >> ZKIT1 - Questions https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1315617651 Message started by Kaloyanr on 09/10/11 at 02:20:51

Title: ZKIT1 - Questions Post by Kaloyanr on 09/10/11 at 02:20:51 I received the PC board Version (rev 9 2011), Thanks Steve, Now I have some questions: Look at the picture (attached) 1. and N. 1 - In your list this position is writen : 1 Mouser #:    75-516D108M035-E3 Mfr. #:    516D108M035PS6AE3 Manufacturer:     Vishay Desc.:    Aluminum Electrolytic Capacitors - Leaded 1000uF 35volts 20% RoHS:     RoHS Compliant In the board is marked : 25 Volts, Can I use 35 V, that i already have? 2. This is position is empty and only marked (0.1uf), I have 2pcs :       Mouser #:    539-150104J400EC Mfr. #:    150104J400EC Manufacturer:     Cornell Dubilier Desc.:    Polyester Film Capacitors 400V .1UF METAL POLY RoHS:     RoHS Compliant I put 2 in the centre - the position that is marked .1uf 400V, Can I use the other 2 for this that is empty / is this is the same? 3. This is empty i don't find this parts??  330K ??? 4 Is this installed correctly? I think that everything else is correct. Best regards Kaloyan

Title: Re: ZKIT1 - Questions Post by Steve Deckert on 09/10/11 at 05:27:14 1) Yes 2) Yes 3) No, not empty, should be 330K 1/2 watt metal film 4) Looks OK although a 1 Watt resistor is large enough to handle the current and smaller in size.

Title: Re: ZKIT1 - Questions Post by Kaloyanr on 09/10/11 at 05:40:12 3} which one: http://ca.mouser.com/ProductDetail/Vishay-Dale/RN65D3303FB14/?qs=sGAEpiMZZMukHu%252bjC5l7Ybd7x5Wh9xkJenTENJ716kM%3d http://ca.mouser.com/ProductDetail/KOA-Speer/MF1-2LCT52R334J/?qs=sGAEpiMZZMukHu%252bjC5l7YdR7WwS3DBCGC89Yj7PFZXw%3d

Title: Re: ZKIT1 - Questions Post by dank on 09/11/11 at 22:30:17 5% tolerance is fine.  1% works too, but there is no need to spend the extra money. Dan

Title: Re: ZKIT1 - Questions Post by Kaloyanr on 09/12/11 at 03:08:10 Almost finished...

Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved.