Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZKIT 1 Support forum >> Anticipating https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1273937122 Message started by Hank on 05/15/10 at 16:25:22 |
Title: Anticipating Post by Hank on 05/15/10 at 16:25:22 Hopefully, my ZKIT1 will arrive mid-week, perhaps some questions as I anticipate construction. I'm not a modder so I will be building the kit without changing parts, using the wood board method. 1) Any suggestions on anchoring the power cord on the board? 2) I see some have encountered hum. Are there any steps I should take in the construction to minimize this problem? 3) I have one amp I constructed on a wooden board, hum is minimal until you crank up the tone-preamp section 4) The suggested test points, are they measured between the letter point and ground? I'm sure when i open the package, there will be more questions. Until then, thank you for the help. Regards, Hank |
Title: Re: Anticipating Post by Alan H on 05/15/10 at 20:44:52 IMO a board is not a good long-term solution. Out of a case, it leaves dangerous voltages exposed, and if after building it you put the board in a case ... well why not build it into a case to start with? If you're not up to case-work - and it's not everybody's cup of tea - , then find a friend who is, or pay a local carpenter. THis is an amp you may well want to enjoy for a long time! You can see pics of my build at http://www.jet5.com/triode.php. If doing it again, I would make the case slightly bigger. My tuppence worth (UK version of 2c) 2) Read the hum thread in this forum - several builders have reported success. It worked for me. 4) Yes. Multimeter between ground and voltage point. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |