Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl OLDER DECWARE GEAR SUPPORT >> TORII MK II Push Pull amplifier >> More on Fuses https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1263581422 Message started by nsj on 01/15/10 at 18:49:47 |
Title: More on Fuses Post by nsj on 01/15/10 at 18:49:47 I notice that on the fuse holder on my Torii Mk2, it states "Use only with a 250V Fuse". Also, on the bottom of the Decware power cord it says "10A 250V". However, both the original (blown) fuse and the spare fuse in my amp are 6A 125V. What fuses do you others have in your Torii's and what is the proper fuse? I wonder if that is what has caused both Bill's and my issues? |
Title: Re: More on Fuses Post by BLFST on 01/15/10 at 21:43:36 Neil, Mine came with a 5A 125V fuse. The unit came directly from Decware as a new unit, so I assume that is what is supposed to be there. bill |
Title: Re: More on Fuses Post by Rivieraranch on 01/15/10 at 22:52:05 Unless I am mistaken, you all should be using "fast blow" fuses for this gear. Look in the manual for a definitive answer. |
Title: Re: More on Fuses Post by BLFST on 01/16/10 at 00:58:17 yes, the fuses are to be fast blow |
Title: Re: More on Fuses Post by Rivieraranch on 01/16/10 at 15:20:08 I recall that when I visited my local Radio Shack to get fuses for my MLB they were so damn retarded that they did not carry what I needed. I ended up ordering fuses directly from DECWARE, which is a sane option, rather than aggravating you life driving around looking for these. |
Title: Re: More on Fuses Post by nsj on 01/16/10 at 16:03:51 RR, That's certainly a viable option. Where do you usually order tubes from - Decware as well? |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |