Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZKIT 1 Support forum >> Another nice build! https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1247675863 Message started by Steve Deckert on 07/15/09 at 17:37:43 |
Title: Another nice build! Post by Steve Deckert on 07/15/09 at 17:37:43 Quote:
Jerry, The CCE mod requires you to modify the circuit board by cutting the trace between pins 3 and pins 6. Then you can install a 0.1uf 400 volt poly cap between the two pins. Steve |
Title: Re: Another nice build! Post by Alan H on 07/15/09 at 23:26:48 Hmmm - I installed the Christmas mod capacitors, but didn't cut any traces. Pins 3 and 6 do not look connected on the schematic, nor on the graphic of the board in the assembly instructions. (I presumed that the NC beside pin 6 meant not connected). Steve, is it the traces between pins 3 and 8 which need to be cut? |
Title: Re: Another nice build! Post by Steve Deckert on 07/16/09 at 13:21:24 Some of the early boards did not have 3 and 6 connected, the later ones did. |
Title: Re: Another nice build! Post by Alan H on 07/16/09 at 17:01:51 Ta. I must have an early board - looking at my photographs, no traces on either side attached to pin 6. Any other differences with the early boards? NB I was wrong - it is a later board, and pins 3 and 6 are connected beneath the tube holders. |
Title: Re: Another nice build! Post by Steve Deckert on 07/16/09 at 23:49:05 The early boards had a full shield that proved to be have a greater potential to cause noise problems than it did to prevent noise problems so it has been eliminated from the current production. Steve |
Title: Re: Another nice build! Post by Alan H on 07/17/09 at 00:41:46 EDITED Steve - turns out I have a later board (rev 7 2009). Now I know where I stand. Thanks. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |