Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Deathbox Support Forum >> Is the following Driver suitable? https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1243992319 Message started by paulandersonnz on 06/03/09 at 02:25:19 |
Title: Is the following Driver suitable? Post by paulandersonnz on 06/03/09 at 02:25:19 Hi there, I would like to know if the following driver will be suitable for DBK10: Make: Rockford Fosgate Model: T110D4 Description: 10" POWER T1 4-Ohm DVC Subwoofer Impedance: 4-Ohmx2 Power Handling: 600 Watts RMS, 1200 Watts Max Voice Coil Diameter: 3" anodized aluminum Motor Size: 102 oz. double stacked Fs (Hz): 36 Re (Ohms): 6.2 Le (mH): 4.6 Qms: 5.68 Qes: 0.67 Qts: 0.60 Vas (Liters): 15.8 Sd (cm2): 310 SPL (1w/1m): 82 dB Xmax (mm): 14 Woofer Displacement: 0.065 cu. ft. Cutout Diameter: 9.3125 in. Mounting Depth: 6.25 in. Rec. Sealed Enclosure: 0.75 cu. ft. Rec. Vented Enclosure: 1.5 cu. ft. Vented Tuning Frequency: 38 Hz I appreciate this woofer has low sensitivity, but it has higher power handling and I have access to a very high power amp to run it. |
Title: Re: Is the following Driver suitable? Post by HT-EXT on 06/03/09 at 11:31:02 The reason for the low effiency is prolly due to the high X-max and power handling. It should be fairly impressive in the DB. With the amount of air that sub can push make sure you round off or router the port. Build it and boom. HT-EXT |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |