Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Housewrecker Support Forum >> HWK 15 PLANS - UPDATED https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1185989764 Message started by Steve Deckert on 08/01/07 at 18:36:03 |
Title: HWK 15 PLANS - UPDATED Post by Steve Deckert on 08/01/07 at 18:36:03 PLANS FOR THIS CABINET DESIGN HAVE BEEN UPDATED |
Title: Re: HWK 15 PLANS - UPDATED Post by Bart_West-VL. on 08/02/07 at 08:40:39 Woohoo, ain't I a lucky bastard!?! Just updated a few weeks before I was planning to build one. Now if I could just figure out if those four radio shack 15" woofers would go low enough for HT... :-/ |
Title: Re: HWK 15 PLANS - UPDATED Post by viper926dave on 08/02/07 at 23:05:02 i would like to see the old plans left on here |
Title: Re: HWK 15 PLANS - UPDATED Post by Bart_West-VL. on 08/02/07 at 23:49:55 The old one's are replaced by the new one's, so no longer visible. (at least I think so...) |
Title: Re: HWK 15 PLANS - UPDATED Post by viper926dave on 08/03/07 at 14:19:13 Bart_West-VL. wrote on 08/02/07 at 23:49:55:
yes i see that but would be nice to also have the old plans visible to as their is different measurements and more info for different subs (8,10,12,15 and 18 inch)new plans show 15 inch only |
Title: Re: HWK 15 PLANS - UPDATED Post by Bart_West-VL. on 08/03/07 at 16:44:30 There's a small difference in measurements, but, imho, the new one's are at least as clear as the previous. Bart. |
Title: Re: HWK 15 PLANS - UPDATED Post by jtomlinson on 05/29/17 at 22:41:04 OK folks which is it for the speaker holes. On one drawing it has 14 inches on the other drawing it has 6 and three fourths inches (13.5 inches). Come on play far for us light in the brain power. JimT |
Title: Re: HWK 15 PLANS - UPDATED Post by Steve Deckert on 06/08/17 at 02:20:49 Hi JimT, The cutout diameter is actually always determined by the specific driver(s) you intend to use. The frame sizes vary quite a bit among 15 inch woofers so you have to look at the data sheet for drivers actual dimensions. Steve |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |