Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Housewrecker Support Forum >> New House Wrecker https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1177360988 Message started by Barrie on 04/23/07 at 21:43:08 |
Title: New House Wrecker Post by Barrie on 04/23/07 at 21:43:08 Just finished my HW cabinet yesterday. Will be installing the drivers this evening. I've got four 15", dual voice-coil speakers and I'm wondering if there are any recommendations as to how to wire them. If I parallel each shelf-pair, that will be 4 ohms. Then, if I series the two pairs, I will be back to eight ohms. Or, I could series all four speakers and end up with 32 ohms. I will have terminals on the outside of the HW box for each speaker, so it will be easy to change the configuration. Any recommendations? Barrie, Missoula, Montana |
Title: Re: New House Wrecker Post by Adrian on 04/23/07 at 21:56:50 the recommendations depend on what amp you're going to power it with. what amp do you have for your HW ? |
Title: Re: New House Wrecker Post by Barrie on 04/23/07 at 22:21:18 The amp is quite old, probably 25 years, at least. It's an ESS, made for Heil when he was building the big cabinets with 2 each 12' and the Heil air-transformers. One channel of this amp seems to drive my WO-32 quite well. Barrie |
Title: Re: New House Wrecker Post by 60_and_up on 04/24/07 at 02:33:42 Barrie wrote on 04/23/07 at 22:21:18:
32 is very efficient. |
Title: Re: New House Wrecker Post by Adrian on 04/24/07 at 16:31:44 do you plan to bridge the amp ? i assume it's stable down to 4 ohms in stereo. so if you bridge it, i'd wire the subs for a final load of 8 ohms :) |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |