Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Wicked One Support Forum >> Bass Guitar Cab questions https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1156421670 Message started by fooze on 08/24/06 at 12:14:30 |
Title: Bass Guitar Cab questions Post by fooze on 08/24/06 at 12:14:30 After being inspired by bassman's thread on using a wicked one as a bass cab, I want one too! I'd like to use the decware drivers but it'll cost a mint to get them to Australia. I found these ones, are they suitable to put in the WO? 10inch (250mm) High Power Polycone Woofer This 250mm driver has a black polypropylene cone with a rubber surround, and high power handling. It is an excellent driver if you need high power but don't want to spend a lot. It is suitable for both vented and sealed enclosures. Specifications: - Nom impedance: 8ohms - Power handling: 160watts RMS - Frequency range: 29Hz - 2500Hz - Sensitivity: 91dB 1watt 1metre - Voice Coil Resistance (Re): 6.9ohms - Resonant frequency (fs): 29Hz - Mechanical Q factor (Qms): 7.632 - Electrical Q factor (Qes): 0.364 - Total Q factor (Qts): 0.347 - Equivalent Volume (Vas): 98Lt - Cone Area (sq m): 0.0346 Typical Sealed Box Application: - Box volume (litres): 32Lt - Tuning Freq (Hz): 57 --3db Freq (Hz) 58 Qtc: 0.707 Inside Cabinet Dimensions: 333(W); 258(D); 407(H)mm Also, after doing the full range mods (opening throat and reversing baffle) is it still possible to use 4 drivers isobarically? |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |