Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Deathbox Support Forum >> Why the cutout in panel (B) ?
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1150466293

Message started by GaryK on 06/16/06 at 13:58:13

Title: Why the cutout in panel (B) ?
Post by GaryK on 06/16/06 at 13:58:13

I understand that panel (B) is attached to panel (A) to make the removeable lid, but I am not sure why we are cutting the round hole in it. If we need the additional stiffness, then why cut a hole in it. More room for the speaker magnet?
No big deal, but I am curious.

Title: Re: Why the cutout in panel (B) ?
Post by Adrian D. on 06/16/06 at 14:01:18

Bob Z said the cutout is for reduction of standing waves.
another reason would be that panel b would be smaller in volume.

Title: Re: Why the cutout in panel (B) ?
Post by GaryK on 06/16/06 at 14:07:00

OK, sounds reasonable. After all whats one more hole after I have the router all set up and making clouds of beautiful MDF dust!
Anyone else thought we could make womens face powder out of all the MDF dust from these projects:)

Title: Re: Why the cutout in panel (B) ?
Post by Lee in Arkansas on 06/16/06 at 14:56:54

I was seriously thinkin' that the other day(face powder), while making my little rip-saw table.