Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Wicked One Support Forum >> Help with angles
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1147300580

Message started by aznboi3644 on 05/10/06 at 22:36:19

Title: Help with angles
Post by aznboi3644 on 05/10/06 at 22:36:19

Hey guys I'm new to this forum.

I'm wanting to build a 36" by 36" wicked one box for a pair of rockford 10's I have laying around.

I have experience with building sub boxes but not with angled cuts. On the plans on the website it says that almost all cuts can be made on one setting.

What is the easiest way to join the boards together?

Thanks

Dom

Title: Re: Help with angles
Post by Hotsauce on 05/10/06 at 22:56:11

Screws and Gorilla glue.

John C.

Title: Re: Help with angles
Post by aznboi3644 on 05/11/06 at 20:54:09

Sorry guys what I meant was with the 36x36 box what is the angle that most of the cuts will be??

My bad.

Title: Re: Help with angles
Post by BIG_GEOFF on 05/12/06 at 01:16:28

It says it on the WO plans page.

It said
Quote:

Now take a protractor, and decide how you want to join your panels. You may wish to end-join them or miter them. The determining factor will be the abilities of your table saw. I recommend drawing the joints on your masterpiece too. That way you wont forget how you're planning to join each panel.

You'll be pleased to find out there is a way to join the panels (end-join) so that almost every angle in the design can be cut from one setting on your table saw. In other words, most of the angles in this design are identical, no matter what size you picked for the height of the enclosure. If you think this is getting rather amazing, wait until you hear the sound quality of the perfectly flat, extended response of this horn and the incredible efficiency!

Hope that helps a bit.

-Geoff

Title: Re: Help with angles
Post by aznboi3644 on 05/12/06 at 05:22:14

Thanks geoff

Title: Re: Help with angles
Post by aznboi3644 on 05/12/06 at 05:52:21

aznboi3644 wrote on 05/12/06 at 05:22:14:

Thanks geoff

Also, what would you guys here think about these RF subs http://www.rockfordfosgate.com/ez2/ModelInfo/ModelInfo.asp?ItemKey=10060203
in a 36x36 wicked one?