|
Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl AUDIO FORUMS >> TROUBLESHOOTING >> Decware ZMA - Am I Living Dangerously https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1788661268 Message started by NothingButTreble on 09/06/26 at 03:21:08 |
|
Title: Decware ZMA - Am I Living Dangerously Post by NothingButTreble on 09/06/26 at 03:21:08 I have the following setup: One set of Klipsch Forte IV Speakers I have just a regular Sony str an 1000 receiver as 5.1 setup with Forte IV, KLF C-7 center, two rear speakers. I have the turntable --> phono preamp --> Decware ZMA --> Forte IV I am using the Douk VU3 Pro to switch between the two amplifiers. I am always careful to turn everything off before switching to the other amplifier. But what if, at some point, somebody switches while the ZMA is still on? It is my understanding that is not good, most likely bad, and potentially a disaster. That's why I'm very careful. So in the scenario that the ZMA is still on, playing from the turntable, and suddenly is disconnected from the speakers. Not good. Just bad. A disaster. |
|
Title: Re: Decware ZMA - Am I Living Dangerously Post by CAJames on 09/06/26 at 04:20:30 I think how bad it is depends on how long you play the ZMA without a load. The longer you do it the worse it gets, but I can’t put any numbers on it. Maybe Steve could. What would solve the problem is swapping in e.g. 8 ohm dummy loads when you swap out the speakers, if you can figure out a way to pull that off. |
|
Title: Re: Decware ZMA - Am I Living Dangerously Post by PointThatThing on 09/06/26 at 06:57:23 At risk of hijacking the thread…I can’t offer any intelligent answer to your question but you mention you are running ZMA through Forte 4. I have Forte 4 and have ZMA on order. I’m. 98% settled on ZMA, but in the near 3 years so far wait I have fluctuated in my thoughts. I think I still want ZMA but any downsides / regrets for you? |
|
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |