Forums https://www.decware.com/cgi-bin/yabb22/YaBB.pl AUDIO FORUMS >> General Discussion and Support >> Optimal input voltage for Sarah? https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1752175338 Message started by saxguy on 07/10/25 at 20:22:18

Title: Optimal input voltage for Sarah? Post by saxguy on 07/10/25 at 20:22:18 I am going to be using the T+A DAC 200 with the Sarah.  I'm pretty sure that when the DAC 200 is set to line level output, the voltage is 2.5 Vrms with the RCAs.  Is this in the optimal range, or is it too high for the input of the Sarah?   With my Alan Eaton 45 monoblocks, it overdrives them slightly when using the DAC 200s line level setting.  It's not a big deal, as the DAC 200 has a stepped resistor volume control, so it still stays analog throughout the volume range and I could always dial it in to a more optimal level in order to use the volume knobs on the Sarah for everything.

Title: Re: Optimal input voltage for Sarah? Post by Steve Deckert on 07/11/25 at 16:33:40 2.5 volts is fine, no issue.

Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved.