Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Wicked One Support Forum >> Can you run these T/S specs for me
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1134010187

Message started by haydenlake on 12/08/05 at 01:49:47

Title: Can you run these T/S specs for me
Post by haydenlake on 12/08/05 at 01:49:47

Hello, I'm going to be making my second WO 36x36x14 (pannels) for a pair of 12" Kove Armaggedon Z's I just picked up.

The T/S specs I have and ran on WINisd came up at .4 for the sealed section. And that seems a bit small to me.

If anyone could run these through any program you might have I would really appreciate it. Any comments would be great too. I think the fairly low inductance, kinda high sens and decent xmax, should have this thing pounding.

Power is already taken care of at 2500wrms at 4ohm

Thanks,
*Power Handling: 800 watts RMS *VCdia: 3" *Le: 2.5 mH *Nominal impedance: 4 ohms per coil *Re: 3.0 ohms *Frequency response: 20-300 Hz. *Magnet weight: 192 oz. *Fs: 34 Hz *SPL: 90 dB 2.83V/1m *Vas: 1.2 cu. ft. *Qms: 5.33 *Qes: .39 *Qts: .36 *Xmax: 18 mm

Title: Re: Can you run these T/S specs for me
Post by jodynugent on 12/22/05 at 14:45:27

Can you give me the EXACT model of the subs, by chance?? Can't find enough info on "12" Kove Armageddon Z's"

Title: Re: Can you run these T/S specs for me
Post by J_Rock on 12/22/05 at 19:15:17

I got .40 cubic feet for sealed chamber in optimum 4th order BP also.

Title: Re: Can you run these T/S specs for me
Post by Jet-Lee on 12/22/05 at 19:37:10

Same here.

Wow.

Title: Re: Can you run these T/S specs for me
Post by nthezone on 12/23/05 at 18:29:31

I ran the measurement in unibox program and it shows a .7 ft3 and 1.3 ft3
1 is optimum and the other is for lowend

Title: Re: Can you run these T/S specs for me
Post by haydenlake on 12/26/05 at 06:09:50

hey guys thanks,

I wound up not trusting WINISD or anything that came out to be .4 bc I just don't think that would sound very good and I've been fooled by WINISD before (it recommended .5 cuft for a sealed SS RLP which really doesn't start sounding good until 1cube).

I wound up going with 1 cube net for the Koves in the WO check out the pics and review here

http://www.soundsolutionsaudio.com/forum/index.php?showtopic=4982