Forums - !K Resisters and 0.1uf Cap

Welcome, Guest. Please Login or Register

04/25/24 at 12:23:06

Forums › SUPPORT FORUMS FOR ZKITS › ZKIT 1 Support forum

‹ Previous topic | Next topic ›

Pages: 1

!K Resisters and 0.1uf Cap (Read 4803 times)

JDUB

Ex Member

!K Resisters and 0.1uf Cap
06/01/11 at 23:20:38

I bought the ZKIT-1 a while ago and have finally got around to staring it.
After putting all the recognizable components on the circuit board I found that the only two resistrors left were light brown and very small. They were supposed to be 1K 2W. I would have expected a larger resistor than the normal small size. They were the same size as the other 1K resistors just a slightly lighter colour. Do I go and buy 2w resistors and if so is there anything special about them.
Secondly the two 0.1uf 400v caps are not marked that way, they have F 104k S 630MEB1 written on them. They look like caps to me rather than resistors are these the correct caps?
Please let me know if I am on the right track.

IP Logged

dank

Seasoned Member

pair of dual 18
Imperials

Posts: 420

Re: !K Resisters and 0.1uf Cap
Reply #1 - 06/02/11 at 12:18:33

Jdub

The parts sound right. "104k" on a capacitor stands for 10 x 10 ^4 pf
or 100,000 pf where 10^6 pf = 1 uf. So 100,000 pf = .1 uf . The resistors ares probably ok too. Any cheep DVM ($10) should verify they are 1k ohm. I belive they are precision wire wound resistors and are quite a bit smaller physically than what you would expect a 2w resistor to be. If you don't have a DVM you should go buy one. You really shouldn't be building a kit like this without one.

DanK

IP Logged

JDUB Ex Member	Re: !K Resisters and 0.1uf Cap Reply #2 - 06/04/11 at 00:44:24 Thanks for your informative reply. Yes I do have a DVM and knew that the resistor was 1K but was unsure that it was 2W as it was very small. I now look forward to finishing my project.
Back to top	IP Logged

Pages: 1

Forums › SUPPORT FORUMS FOR ZKITS › ZKIT 1 Support forum

‹ Previous topic | Next topic ›

UPLOAD IMAGES HERE