Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
CABLE FORUMS >> ZSB >> Using the switcher with two turntables
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1510067380

Message started by Orto on 11/07/17 at 15:09:40

Title: Using the switcher with two turntables
Post by Orto on 11/07/17 at 15:09:40

I have a decware phono pramp with step up inside....I'm adding a turntable with mono rig to my system ....can I run the tables to the switcher and then to the phono pre. ....both cartridges are low output

Title: Re: Using the switcher with two turntables
Post by Archie on 11/07/17 at 16:44:10

My sense is that running a tiny signal through a switch might be an issue compared to running a large signal. So, switching the TTs that way wouldn't be ideal. I take it that your TT doesn't have a SME headshell that you could use to swap between Mono and Stereo carts? Maybe just swapping the interconnects from TT to TT would be a better solution if you really need two TTs?

Title: Re: Using the switcher with two turntables
Post by NormD on 10/10/18 at 03:11:05

I just bought a used ZSB and I get a hum when I use it between my turntable and ZP3. I opened it up and it has resistors on the dual set of inputs. What is the difference between the low level version and the line level version?