Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl EQUIPMENT FORUMS >> ZP3 / ZMC1,2,3 >> Hana EH HOMC Cartridge - ZP3 Compatibility https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1507454609 Message started by Ron on 10/08/17 at 10:23:29 |
Title: Hana EH HOMC Cartridge - ZP3 Compatibility Post by Ron on 10/08/17 at 10:23:29 So I have heard great things about the Hana E series carts. I am tempted to try one but I am not sure they will jive well with the ZP3. The specs for the Hana EH are: Loading:47 kΩ Output: 2 mV I was also looking at a SoundSmith Otello, but that has the same output voltage as well. Any help would be greatly appreciated. Thanks, Ron |
Title: Re: Hana EH HOMC Cartridge - ZP3 Compatibility Post by Acetone on 10/08/17 at 16:42:00 Hey Ron, A few months back I asked Steve that question. His response was: He tries to keep the input into ZP3 at 4mV min for best results. I bought the Ortofon 2m black at his suggestion and absolutely love it. I have upgraded wires, speakers and added Zstage since and the 2m has kept up with the improvements. |
Title: Re: Hana EH HOMC Cartridge - ZP3 Compatibility Post by Archie on 10/08/17 at 20:25:19 While waiting for a ZMC1 to arrive, I ran a LOMC cart (0.45 mv) with my ZP3 but with a CSP3 after. Sounded good but any noise was amplified. So, I wouldn't recommend 2 mv unless you have a pre and your ZP3 is very quiet. If I did the math right, even a 4 mv cart only puts 1/2 volt out of the ZP3. Most of Steve's amps need 2 volts in to achieve full power. |
Title: Re: Hana EH HOMC Cartridge - ZP3 Compatibility Post by Ron on 10/09/17 at 01:12:36 Thanks for the replies! I'll keep an eye on the 2M black or others with higher output. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |