Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZKIT 1 Support forum >> Standoffs for mounting to wood https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1387425520 Message started by MarkO on 12/19/13 at 03:58:39 |
Title: Standoffs for mounting to wood Post by MarkO on 12/19/13 at 03:58:39 I'm making good headway on my ZKIT and have about all the parts I need (just got the 100 ohm resistors, and still need to get a 3 prong cord for the power transformers). I ended up buying #4 woodscrews to mount the PCB, and as those have a coarser thread than the standoffs I ordered I don't think they'll work together. Would an aluminum spacer work ok, or would that be too conductive? |
Title: Re: Standoffs for mounting to wood Post by dank on 12/19/13 at 11:29:35 Aluminum spacer, #4 wood screw, or any metal bolt are all pretty much the same conductivity. Any should work fine in this application..."too conductive" should not be a problem. Dan |
Title: Re: Standoffs for mounting to wood Post by MarkO on 01/17/14 at 00:08:51 Thanks! I eventually to some #6 standoffs and screws for the circuit board, and used the #4 screws for the output transformers. Need to get some shorter #6 screws to attach the power transformer, but it's up and running! |
Title: Re: Standoffs for mounting to wood Post by MarkO on 01/18/14 at 23:49:01 Bad shot, but it's no prettier well lit. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |