Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR ZKITS >> ZKIT 1 Support forum >> ZKIT1 Hum https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1371678283 Message started by Mike B on 06/19/13 at 22:44:38 |
Title: ZKIT1 Hum Post by Mike B on 06/19/13 at 22:44:38 Just finished the Zkit1 and it has a 5.5mv hum. I isolated it to the amp, took the input tube out and the hum is gone. Any help with this problem will be appreciated. The amp sounds wonderful but I would like to get this hum below 3mv. Mike B |
Title: Re: ZKIT1 Hum Post by Lon on 06/19/13 at 23:23:44 Believe me, I am far from an expert, but. . .have you tried another input tube? |
Title: Re: ZKIT1 Hum Post by Mike B on 06/20/13 at 03:18:25 Thanks for the reply, Lon. Yes, I did try serveral input tubes, and also rectifier tubes. Maybe Steve will see this post and give me a suggestion. Mike B |
Title: Re: ZKIT1 Hum Post by dank on 06/20/13 at 12:14:15 I think the Zkit board has been redone to correct some of the problems found and fixed tin the "Hum Problem" thread: https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1257041114 but you should read through that. I believe the "Virtual CT for Edcor Heater Wires - WOW!" thread is still producing results: https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1352929896 good luck Dan |
Title: Re: ZKIT1 Hum Post by Lon on 06/20/13 at 13:27:05 Well Mike, good that you tried some other tubes. I have to say that most of the time I've had hum issues with a Decware component it's been a tube that was responsible. |
Title: Re: ZKIT1 Hum Post by mboxler on 06/20/13 at 14:39:05 Hey Mike I assume you mean you replaced the output tubes, or did you go with tube rectification instead of the diodes on the board? I know pictures are a pain, but perhaps one of us can see something. Mike |
Title: Re: ZKIT1 Hum Post by Mike B on 06/20/13 at 22:29:37 Mike, I replaced the input tube with new ones, no change. I also decided to use tube rectification and tried changing rectifier tubes but there was no change. The hum is not there with the input tube removed. I built and original zen amp, and there is no hum the AC voltage on the speaker outs is less than 2mv, so the 5.5mv I have now is bothersome. Since the hum is equal on both side, I'm checking the circuitry around the input tube. I'll try to post pictures later tonight. Mike B |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |