Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> Wicked One Support Forum >> Help needed for 6.5" subs https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1173728713 Message started by maff on 03/12/07 at 20:45:13 |
Title: Help needed for 6.5" subs Post by maff on 03/12/07 at 20:45:13 Hi, I recently got a pair of 6.5" raptor 6 subs. http://www.monacor.com/int/en/produktseite_carpower.php?artid=4418&spr=EN&typ=u Been looking on this site how to scale down the WO build, but am a bit stuck. My initial thought was to make measurements .65 of the size of the original plans, but the volume is affected dramatically. should i scale it untill i get the right volume in the rear chamber for the sub? Advice would be much appreciated. Thanks, Matt |
Title: Re: Help needed for 6.5" subs Post by maff on 04/05/07 at 14:10:28 It sounds fantastic, after completely sealing with silicone and testing properly i was supprised how low and tight the bass was for 6.5" subs. The final measurements were 22x24x7.5, i simply scaled down until the rear chamber was of that required for my subs. I was lucky it worked, i get no distortion at all. |
Title: Re: Help needed for 6.5" subs Post by JRock on 04/07/07 at 20:38:25 Excellent scale example. I have had good experience scaling, and so have you- although others have not. I wonder why? |
Title: Re: Help needed for 6.5" subs Post by aznboi3644 on 04/07/07 at 21:04:12 very nice...hows the output??? |
Title: Re: Help needed for 6.5" subs Post by 60_and_up on 04/08/07 at 00:34:17 web site sais your drivers can take 100wrms each, i hope you have a 400wrms amp on that sexy-ass box. you will also probably be able to 'tune' that box by slideing it closer and further away from the rear of the car, even a few inches will effect the 'loading' it has off the rear hatch. even up to about 1" close will be fine. |
Forums » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |