Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SPEAKER FORUMS >> HDT >> HDT MKII
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1170893596

Message started by Falconer on 02/07/07 at 23:13:16

Title: HDT MKII
Post by Falconer on 02/07/07 at 23:13:16

Has anyone built the MKII version of the HDT? ???

Title: Re: HDT MKII
Post by ZYGI on 02/08/07 at 00:07:18

Falconer,

I have, but thats a given, right. We've also done some HDT to HDT-MKII conversions.

Bob

Title: Re: HDT MKII
Post by Falconer on 02/08/07 at 01:09:45

Zygi,
Yes it is ;D. I was wanting to know about the dispersion plates on top. If I remember correctly the upper plate is identical to to all HDT models with a half moon cut out of the front. The bottom one has a vee notch in the back to match the top of the speaker cabinet along with a half moon cutout in the front, is this right? Also, how does the tweeter mount onto the cabinet? I thought that I read somewhere in the forum that Decware would sell the drivers for DIYers to build their own units

Title: Re: HDT MKII
Post by ZYGI on 02/08/07 at 03:52:28

Falconer,

Yes the top plate is the same to all. The lower plate is the same with a 3"x3" cut out which would form a diamond shape, starting at the center of the t-line back. Steve has come up with a tensioning screw to hold the tops in place, this I haven't seen, yet.

The tweeter mounts on the top with a piece of wood which resembles a section of hand rail, its cut at a 3 degree angle, and sets back 3/4' from the front of the cabinet.

Bob

I'm not sure its on the site, but yes we do sell the parts for doing so. You'd have to e-mail Steve for the price though.