Forums - Print Page

Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SUPPORT FORUMS FOR DECWARE SPEAKER PLANS >> DECWARE Imperial support forum >> Imperial braceing *picture*
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1158998012

Message started by Moog on 09/23/06 at 07:53:32

Title: Imperial braceing *picture*
Post by Moog on 09/23/06 at 07:53:32

Is this right

I seen this in another thread but can't remember which one

Title: Re: Imperial braceing *picture*
Post by gexter on 09/24/06 at 01:52:15

No
not to my knowledge,
there are three long barces and then the side braces. then the two braces you are asking about go on each side of the center one bracing to the back directly.
But Steve likes to build stuff strong so you may be ok with what your doing.

your not building from plans are you?

Title: Re: Imperial braceing *picture*
Post by Moog on 09/24/06 at 09:38:06

Hey gex
thanks for the reply
yes 10 dollar download
I see mid brace ending in the compression chamber?

But then again my first layout was hooped, too many beers
vocal pitch for miles/no bass

Title: Re: Imperial braceing *picture*
Post by gexter on 09/25/06 at 03:47:27

Akkk
my mistake I was thinking about a SO.
Your fine on what your doing. the compresion chamber on a Imperial is not braced
So your bracing is just a bonus. because its not sealed in a Standard Imp flex is not as bad in the chamber.
But you talking to a guy that only has built a cardboard one and a wood cardboard hybrid SO.
Build em strong whenever you can..
looks great.