Forums
https://www.decware.com/cgi-bin/yabb22/YaBB.pl
SPEAKER FORUMS >> HDT >> Parallel network for fe206e
https://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1147283952

Message started by franksmith on 05/10/06 at 17:59:12

Title: Parallel network for fe206e
Post by franksmith on 05/10/06 at 17:59:12

http://www.6moons.com/audioreviews/firstwatt/13.gif

Any hint of what would be this parallel network to flatten the response of the drivers ?

My own way of compensation is listening at 20-25 degres of angle but I'm thinking of a LR filter or something like that.

Title: Re: Parallel network for fe206e
Post by franksmith on 05/10/06 at 18:05:11

Oups, didn't read the first two pages of the article.


Quote:
Most of the examples we will examine do not require true current-source amplifiers, only amplifiers of quite high output impedances. Most of these cases will be happy with an output impedance of approximately 47 ohms or so and prefer 47 ohms loaded in parallel with the output of a current source. That being the case, you can build a Thevenin Equivalent of such a current source by placing a large resistor (here later referred to as R0) in series with the output of a high wattage voltage source amplifier and get similar results.


Everything is there :
http://www.6moons.com/audioreviews/firstwatt/firstwatt_2.html

Title: Re: Parallel network for fe206e
Post by Mr Content on 05/10/06 at 18:17:28

Just a simple circuit like this would do



Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.