Welcome, Guest. Please
02/27/17 at 14:16:40
DIY Interconnects and Speaker Cables (Read 1940 times)
Still like that old
time Rock and Roll!!
DIY Interconnects and Speaker Cables
06/09/13 at 04:54:28
I am gonna build my own interconnects and speaker cables using DH Labs cabling, Cardas Quad Eutectic solder, my Hakko FX-888 soldering station, and TechFlex with heat shrink tubing.
Has anyone ever attempted DIY cables and if so....any insight would be greatly appreciated. I am no stranger to soldering, but with using expensive interconnects and wires, just trying to keep the mess-ups to a minimum.
Back to top
Decware ERR's [Bubinga Wood], Zstage [with Beeswax caps], Zbox, Velodyne dual firing sub, Yamaha THX SS A/V Receiver
Jack of all Trades,
Master of None
Re: DIY Interconnects and Speaker Cables
Reply #1 -
08/21/13 at 20:52:08
Wow, no responses to this?
A couple things I'd recommend.
You said you're knowledgeable with soldering, but still, it's good to keep in mind that you need to heat both the wire to be soldered and especially the metal that you're trying to solder the wire to! Both must be warm enough to melt the solder at a touch, not just the wire.
Use heat shrink tubing, and get the good stuff (like 3M ). Heat shrink is a great way to give the cables that finished look.
Try to make cables as perfectly balanced as possible. If one cable is 3' 1/4", then all cables should be 3' 1/4". If it's something you have control over, you might as well take your time and make it perfect.
I find the more expensive the connections are, the easier they seem to be to build, because the company that made them started their design from scratch; so they had the opportunity to make them just the way they wanted.
So take your time, and do them up right.
Back to top
» Powered by
© 2000-2008. All Rights Reserved.