Welcome, Guest. Please Login or Register
Decware Audio Forums
07/31/14 at 18:43:20


Pages: 1
Send Topic Print
DBII Build Help (Read 1537 times)
Pat32
Verified Member
**




Posts: 2
DBII Build Help
08/06/11 at 06:35:47
 
Hello,

Just want to ask;

How should I round the edges on the port of the DBII box?
(any pictures would be great!)

Thank you
Back to top
 
 
  IP Logged
ZYGI
Seasoned Member
****


HR-ONE

Posts: 642
Re: DBII Build Help
Reply #1 - 08/07/11 at 03:07:22
 
Pat32,

Are you speaking of the DBK10 with the 1/2moon cut out? If so, round over the inside edge with a 3/8"radius bit before assembling the cabinet, then once you get the bottom on you round over the outside.

Hope this helps,

ZYGI
Back to top
 
 

All Decware amps and sources, Turning Point Audio speakers
  IP Logged
Pat32
Verified Member
**




Posts: 2
Re: DBII Build Help
Reply #2 - 08/07/11 at 11:29:30
 
Thanks ZYGI for the reply.

Sorry for not providing enough information. Im referring to the DBK212.
However from your advice, the best is to round both sides of the port?
I have rounded the outside but jumped the gun and assembled it.

Will try and round the inside if its the best setup.

Will throw up some more pictures in the build section of the forum!


Thanks for your help.

edit: looking at the decware build, doesnt appear to be any rounding?

Back to top
 
« Last Edit: 08/07/11 at 11:34:06 by Pat32 »  
  IP Logged
pbLarry
Verified Member
**




Posts: 11
Re: DBII Build Help
Reply #3 - 11/10/11 at 23:58:12
 
I'm not sure what I'm actually looking at with the Decware build. The port itself is a mere 1/2" slot at the bottom of the bell shape. I'm building one for my son and do not see any reason to round any of the sufraces.

I do have good equipment and will see if there are any undesirable vorticies or disturbances from the sharp exit points but it's a sub-woofer and mathmatically a clever design that should work well.
Back to top
 
 

60's musician stuck in the digital age
  IP Logged
Pages: 1
Send Topic Print