Welcome, Guest. Please Login or Register
Decware Audio Forums
09/15/14 at 05:10:34


Pages: 1
Send Topic Print
Help with NFX Duct panel (Read 1642 times)
dwolek
Verified Member
**




Posts: 18
Help with NFX Duct panel
04/25/11 at 20:01:09
 
In anticipation of my new Zen Integrated, I'm in the process of building me a set of NFX's - walnut plywood with birdseye maple caps around the driver and top - should be sweet.  

I purchased the plan from the website, but can't figure out the placement of the internal ducts.  Specifically refering to Fig 25, it shows a 4" angled piece that I think traverses top to bottom placed against each V brace with the angle butting against the side panel.  This is shown in Fig 27, but the description seems to be mis-worded.

Anyway, its hard to describe at best, so I was wondering if anyone has a top down picture of duct panel.  If Iím understanding this correctly, the placement of the vertical duct panel will create 4 discrete ports with sound waves travelling around the balls and out each of the side vents.  Arghhh, this is so difficult to verbalize.

Any help is much appreciated.
Darren
Back to top
 
 
  IP Logged
ZYGI
Seasoned Member
****


HR-ONE

Posts: 642
Re: Help with NFX Duct panel
Reply #1 - 04/25/11 at 23:17:40
 
Darren,

If you look at Fig. 22 it shows the top two sit on top of the braces. The bottom one fits under the braces.....

Hope this helps,
ZYGI
Back to top
 
 

All Decware amps and sources, Turning Point Audio speakers
  IP Logged
Pages: 1
Send Topic Print