Welcome, Guest. Please Login or Register
Decware Audio Forums
10/26/14 at 05:28:00


Pages: 1
Send Topic Print
DFR-8 cutout (Read 3128 times)
rmt
Ex Member



DFR-8 cutout
08/09/06 at 02:26:04
 
[quote author=Zygi  link=1146081910/0#1 date=1146097859]The driver cut out (hole) is 3-19/32" R ...the driver is surface mounted.
BobZ [/quote]

On the HDT support forum this was stated by Zygi.  That would make the cutout diameter 7 3/16 in diameter for the DFR-8.  NFX plans show 7 inch dia.  ??? I don't expect my DFR-8 drivers to get here for several days.  Should I wait till they are here before I make my baffle cutouts?
Back to top
 
 
  IP Logged
Steve Deckert
Administrator
*****


If the 1st watt
sucks why continue?

Posts: 2425
Re: DFR-8 cutout
Reply #1 - 08/09/06 at 20:36:54
 
Yes, the DFR-8 cutout is 7-3/16 inches.  The plans are done without knowing what drivers will be used.  Always easier to make a hole bigger then it is to make a hole smaller.  8)
Back to top
 
 
WWW   IP Logged
Pages: 1
Send Topic Print