Forums
http://www.decware.com/cgi-bin/yabb22/YaBB.pl
AUDIO FORUMS >> Home Theater >> 2 Channel DAC in a 9.2 Home Theater?
http://www.decware.com/cgi-bin/yabb22/YaBB.pl?num=1517039647

Message started by beowulf on 01/27/18 at 07:54:07

Title: 2 Channel DAC in a 9.2 Home Theater?
Post by beowulf on 01/27/18 at 07:54:07

Ok, so I may be moving towards the end 2018 early 2019.  I'm looking for a space that will accommodate both a 2 channel stereo setup and 9.2 Dolby Atmos/DTSX setup incorporating my existing 2 channel audio components.

Most of my watching will be streaming from a NAS or online services such as Amazon Prime, HBO-GO, Starz Online and Showtime.  With about 10% or less through a traditional cable box.

I've been out of the Home Theater game for quite a while and enjoy watching movies on my Decware/Omega 2 channel setup with my PC a NAS and McIntosh D100 2 channel DAC.  If I get a new space I would like to try an entry level 9.2 setup and use it in combination with my already stellar Decware/Mac/Omega combo.

My question is ~ if my PC USB out is going to a 2 channel DAC how can I incorporate a 9.2 system into my PC as well?

I have:

1 HTPC that I would use for movies and music with JRiver Media Center
1 Decware Taboo MK II
1 McIntosh D100 2 channel DAC
1 McIntosh C200 2 channel Preamp
1 Rega RP6 TT
2 Omega RS7 Loudspeakers
2 Rythimik Audio Servo Subs
1 Cable Box

In addition I plan on buying 4 in-ceiling speakers, a center channel and 2 rear surrounds and an entry level 9.2 Home Theater Receiver such as the Marantz SR7011.

My current configuration looks pretty much like this:

HTPC (streaming from NAS or online music and video services) > D100 DAC > C200 Pre > Decware Taboo MK II > Omega RS7 Speakers.

I want to continue using my Mac DAC/Mac Preamp/Decware amp for 2 channel music, but then use a Home Theater Receiver when watching movies (but still using the Taboo for left and right channels and the Reciever will power the other channels).  I understand about Home Theater Pass Through and being able to use the Tape Loop on a Preamp if it doesn't have HTPT, but I guess what's confusing me is ...

Because I'm using USB out from my HTPC to a 2 channel DAC ~ will the DAC somehow pass a 5.1 or higher playback signal to my Preamp and then send the signal to the Home Theater Receiver and the HT Receiver will somehow know that it's 5.1 or higher playback signal?  Or am I going to need to find another DAC or a Blu-Ray player with DLNA capabilities as an additional source?

Gosh I'm little confused if I'm even posing the question correctly ;D  let me know if that question doesn't make sense and I'll try to rephrase it somehow. :D

Thanks in advance!

Forums » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.